COATS 1175 Series Balancer - Manual (Page 17)

Important: Always read and follow the instructions. • 11
Manual Dimension Presetting
(Use only in particular cases or
for test)
c1-c2/STATIC/t1-t3/c1-t3 Wheel Rims (use for
setting dimensions in AUTO CALIBRATION)
- Setting:
Press or
Set with the rated width that, in general,
is shown on the rim, or measure width “W” with the
caliper gauge supplied.
- Press the button for more than 2 seconds
- Preset using the nominal diameter “D”
indicated on the tire
- Press the button for more than 2 seconds
- Preset using distance “A” for the inside
of the wheel from the machine.
Note: This setting is also valid for the correction
modes STATIC/t1-t3/c1-t3.
t1-t2 Rims
- Setting:
To go to these functions:
- press one of the two buttons for more than 2 sec-
onds.
- to change press one of two buttons.
- to change press one of two buttons.
- to change press one of two buttons.
Note: when dt2 is not set, dt2 = dt1 + 1” is auto-
matic.
W
A
D
dt1
dt2
At1
At2