COATS 875 Series Balancer - Manual (Page 27)

Important: Always read and follow the instructions. • 21
Unpacking the Unit
1. Remove the shipping carton from the pallet.
2. Remove all loose parts and accessories packed
around the unit.
Remove Balancer from Pallet
3. Remove the shipping bolts that hold the balancer
to the pallet.
Do not use the control panel, control panel
base, accessory storage, faceplate, hood or
shaft to lift the balancer.
Use help to remove the balancer from the
pallet. The unit is heavy and the weight is
not evenly distributed. Dropping the unit
may cause personal injury or equipment
damage.
4. Lift the balancer off the pallet and place it in its
operating location.
5. Install and tighten the threaded stud into the end
of the motor shaft.
Connect to Power
Your factory trained COATS ® Service Technician
should do the final check to verify the power installa-
tion before connecting the balancer to a power supply.
Failure due to improper power connection may void
the warranty.
Initial Testing
1. Plug the unit into an appropriate power outlet. If
the circuit breaker for the outlet is off, turn it on.
2. Turn the balancer on. The power switch is on the
back of the unit.
Hood Installation (Model 875)
1. Install plastic bushing on end of hood tube.
2. Insert hood tube through hole and slide through
hood mounting bracket. The bushing will only fit one
way due to its molding.
3. Install second plastic bushing on the end of the
hood tube protruding from the bracket.
4. Slide on the stop ring. The set screws may need to
be loosened to install slide ring. Adjust the stop ring so
the notch is parallel to the floor when the hood is in the
down position.
5. Install the plug in the end of the hood tube.
6. Tighten the set screws to secure stop ring in
place.
7. Raise the hood.
8. Install hood spring. This attaches to the cam studs
on the hood bar and mounting bracket.
9. Lower the hood.
10. Screw on hood switch with two screws. The
height of the switch will need to be adjusted to ensure
the switch button is up when the hood is down. The
switch button should fit neatly in the cutout of the stop
ring.
11. Connect the switch wiring end to the three-
prong connector on the back panel of the chassis.
12. Test the hood switch with the auto spin feature
to ensure proper installation. If problems check the
height of the hood switch button for proper operation.
CAUTION
CAUTION