Barco GRAPHICS 1208S R9000893 - Manual (Page 10)

Connections
3-1 5975847 BARCOGRAPHICS 1208S 220197
hm
ON
T 1
EO)
PROJECTOR MODE POWER/MAINS
PORT 2
(S-VIDEO)
75 ohm
ON OFF
GREEN : operational
RED : stand-by
352
3
CONNECTIONS
AC Power (mains) Cord Connection
Use the supplied power cord to connect your projector to
the wall outlet. Plug the female power connector into the
male connector at the backside of the projector.
Power Check
Power voltage indication on sticker on the back side of the projector.
The power voltage is indicated by the art. no.
Warning !
Check if the indicated power voltage corresponds to that of the wall
outlet.
Art. No. R9000893 must be connected to a 230 VAC power source.
Art. No. R9000896 must be connected to a 120 VAC power source.
If the wall outlet voltage is different, call a qualified technician for
power adaptation of the projector.
Switching On/Off
The projector is switched ON and OFF using the power (mains) switch
ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image dis-
played) or in the 'stand by mode', depending on the position of the
'power up' dip switch on the controller unit. This DIP switch must be
set during installation by a qualified technician. If you want to change
this start up mode, call a qualified technician.
Stand by indication lamp :
no light up : projector switched off
green color : projector in Operational mode
red color : projector is in Standby mode.
RS 232 O UT RS 232 I N
IR REMOTE
REM OT E IR
RS232 OUT RS232 IN
V NOM
I MAX
FREQ 120/230 Volt
7/5Amp
50/60Hz
685