Barco GRAPHICS 1208S R9000893 - Manual (Page 38)

Random Access Adjustment Mode
6-17 5975847 BARCOGRAPHICS 1208S 220197
Vertical corners
Highlight 'Vertical corners' and press ENTER to start the adjustment.
To make a coarse adjustment of the red or blue horizontal lines in
zone 10, 14, 18 and 22 simultaneously.
Select with or
then <ENTER>
<EXIT> to return. COARSE CONVERGENCE
Select with or
then <ENTER>
<EXIT> to return.
HORIZONTAL SIDES
VERTICAL CORNERS
Hint :
- adjust until the red or the blue horizontal lines are on the green lines
or as close as possible to the green lines.
- during these adjustments, the horizontal convergence adjustments
in zones 10 to 25 will be set to midposition (barscale 50).
Fine Convergence Adjustment.
Use these controls after coarse convergence adjustment to optimize
the convergence of the red and blue image on the green image.
Use the control stick to make horizontal or vertical convergence
adjustments in the selected zone and then press ENTER to move the
box to another zone or EXIT to return to the Convergence menu.
ENTER toggles arrow keys between zone selection and zone adjust-
ment .
EXIT returns to convergence menu
Note : the green convergence adjustments can be added as an
option. When these are available, always start with 'green only'. This
option will also be indicated on the convergence menu.
Highlight first 'Green only' when available with the control stick and
press ENTER to display the convergence adjustment menu.
Continue with red on green and blue on green.
Select with or
then <ENTER>
<EXIT> to return. CONVERGENCE
Select with or
then <ENTER>
<EXIT> to return.
COARSE ADJUSTMENT
RED ON GREEN
BLUE ON GREEN
FINE ADJUSTMENT
GREEN ONLY
RED ON GREEN
BLUE ON GREEN
CONVERGENCE
SEL : select area
using
arrow keys
ADJ : adjust area
using
arrow keys
Toggle between
SEL and ADJ
with <ENTER>
<ENTER> continue
<EXIT> to return
CONVERGE
ADJUSTMENT
70
red image
green image