COATS 6401 Computer Truck Wheel Balancer - Manual (Page 18)

12 • COATS 6401 Truck Wheel Balancer
Direct Drive
Balancing Wheels
Truck Dynamic
1. Select Truck Dynamic mode using the keypad.
2. Set distance gauge, wheel width and wheel diam-
eter as indicated in BALANCING PROCEDURES.
3. Lower hood and push START.
4. Raise hood and attach weight as indicated in BAL-
ANCING PROCEDURES.
5. Lower hood. Respin wheel to obtain 0.00 reading.
Truck Static
Note: This method is equivalent to a bubble balance.
1. Select Truck Static mode using the keypad.
2. Set distance gauge, wheel width and wheel diam-
eter as indicated in BALANCING PROCEDURES.
3. Lower hood and push START.
4. Raise hood and attach weight as indicated in BAL-
ANCING PROCEDURES.
Note: Use two standard clip weights to split the
weight on the inner and outer rim.
Note: One weight, using the total imbalance amount,
may be used on the inside.
Note: If one tape weight is desired on the drop cen-
ter then set the rim diameter “D” 1 1/2" smaller than
tire size.
5. Lower hood. Respin wheel to obtain 0.00 reading.
RV Dynamic
1. Select RV Dynamic mode using the keypad.
2. Set distance gauge, wheel width and wheel diam-
eter as indicated in BALANCING PROCEDURES.
3. Lower hood and push START.
4. Raise hood and attach weight as indicated in BAL-
ANCING PROCEDURES.
5. Lower hood. Respin wheel to obtain 0.00 reading.
Car Dynamic
1. Select Car Dynamic mode using the keypad.
2. Set distance gauge, wheel width and wheel diam-
eter as indicated in BALANCING PROCEDURES.
3. Lower hood and push START.
4. Raise hood and attach weight as indicated in BAL-
ANCING PROCEDURES.
5. Lower hood. Respin wheel to obtain 0.00 reading.
START
Standard clip
weight will be
attached here.
Standard clip
weight will be
attached here.