COATS 9500 Electro-Hydraulic Tire Changer - Manual (Page 5)

COATS 9500 Tire Changer • 1
1.0 Introduction
Congratulations on purchasing the COATS ® 9500
Electro-Hydraulic Tire Changer.
This tire changer is designed for ease of operation,
safe handling of rims, reliability and speed.
With a minimum of maintenance and care, your tire
changer will provide many years of trouble-free opera-
tion.
Instructions on use, maintenance and operational
requirements of the machine are covered in this man-
ual.
Store this manual in a convenient place for
future reference. Read this manual thor-
oughly before using the machine.
1.1 Use limitations
The COATS model 9500 tire changer is intended to be
used as a device to demount and mount tubeless truck
tires with the following specifications:
Maximum Tire Diameter: 90 1/2 inches (2300 mm)
Maximum Tire Width : 43 inches (1100 mm)
This device shall be used in the application for which
it is specifically designed. Any other use shall be con-
sidered as improper, and not WITH THE SPECIFICA-
TIONS OF THIS UNIT. In particular, this device is not
suitable to inflate tires. Inflation of tires shall be carried
out in an approved inflation safety cage. The manufac-
turer shall not be considered liable for possible damage
caused by improper, wrong or non-SPECIFIED use.
1.2 Notice
This manual is a part of the product. Read carefully
the warnings and instructions of this manual since they
provide important information concerning safety and
maintenance.
1.3 General Safety Instructions
Any misuse or modification of this device or of its
parts or components not previously authorized by the
manufacturer relieves the manufacturer from any dam-
age consequent or related to the above mentioned
misuse.
No modifications should be made without consulting
COATS ® . Removing or bypassing any safety devices or
warning labels of the machine is a violation of the
safety regulations.
The use of this device is allowed only in locations
with no explosion or fire hazards, consistent with state
and local fire codes.
This equipment is designed to use original or manu-
facturer supplied spare parts and accessories only.
The installation shall be carried out only by qualified
personnel and within the scope of the instructions pro-
vided in this manual.
Check for possible dangerous conditions during the
operation of the machine. If such a case exists stop the
machine immediately. In case a defective functioning
condition stop using the machine, immediately and call
the authorized distributor for assistance.
All electrical connections shall be per-
formed by a licensed electrician. All service
must be performed by an authorized service
technician.
1.4 Nomenclature
Before installing and using the tire changer it is sug-
gested that you become familiar with the nomencla-
ture of the machine’s components (fig.1).
Fig.1
1 - 8 Position Switch
2 - Chuck Switch
3 - Emergency Stop
4 - Tool Holder Arm
5 - Main Switch
6 - Tool Holder Carriage
7 - Foot Board
8 - Jaws
9 - Self-centering Chuck
10 - Chuck Arm
11 - Chuck Rotation Control Pedal
12 - Mount/Demount Tool
13 - Electric Cabinet
14 - Tool Holder Arm & Release
WARNING
WARNING