COATS CDH-9551 Electric-Hydraulic Tire Changer - Manual (Page 4)


lbs 2745
(KG. 1245)
B/2
B/1
A/2
6
Once the packing material has been removed, check the machine visually for any signs of damage.
Keep the packing materials out of the reach of children as they can be a source of danger.
N.B.: Keep the packing for possible future transport.
7 INSTALLATION
Choose the place the machine is to be installed in compliance with current work place safety regulations. The floor should not be broken
or uneven so that the machine will be stable and the platform rollers can move freely.
If the installation is outdoor, it must be protected by some kind of roofing against rain.
The following work environment conditions are applicable:
Relative humidity: from 30-95% without condensation;
Temperature: from 32°-131° F (0-55° C.)
UNPACKING
7.1
INSTALLATION PLACE
ATTENTION!
The machine must not be operated in explosive atmospheres.
Maximum machine space requirements are 88.2x6.3 inches (2240x 1640 mm) with a minimum distance from walls as shown in the dia-
gram.
CAUTION! These measurements are also the tyre changers working range. Persons other than specially trained and authorized operators
are expressly forbidden to enter this area.
Position the tire changer lifting it with the specific bracket (1, Fig. A) with the tool carrier arm (2, Fig. A) lowered all the way, the spindle
(3, Fig. A) closed and the tool carrier slide (4, Fig. A) at its stop close to the arm.
The mobile control unit has no fixed position, but it must be
positioned in a way that the user can observe the machine when working
7.2
WORKPLACE REQUIREMENT