COATS CDH-9551 Electric-Hydraulic Tire Changer - Manual (Page 6)

6
7.3 ELECTRIC HOOK UP
Before making any electric hook up, check to be certain that the mains voltage corresponds to that stamped on the voltage tag (at-
tached to the cord near the tire changer’s plug).
It is absolutely essential that :
- the system is equipped with a good grounding circuit.
- The current instake is adeguately protected against overcurrents with fuses or automatic magneto-thermic switch.
Note the required power draw as highlighted on the data plate fixed to the tire changer. Check to make sure the shop electric wiring
circuit is dimensioned sufficiently to carry this.
Work on the electric system, even if minor, must be done exclusively by professionally qualified electrician.
Manufacturer shall not be liable for any injury to persons or damage to things caused by failure to comply with these regulations and
can cancel warranty coverage.
Connect the machine to the mains, switch “ON” (5, fig. B/7) and check that the gearbox motor rotation corresponds to the indicating
arrow (6, fig. B/6). If not, switch two wires in the plug .
SENSE OF ROTATION CHECKS
B/6
B/7
1
5
6