Comark EV SOFTWARE - Manual (Page 10)

9
3.2 Introducing a logger for the first time
Select a logger and press the navigation button on the front. Diligence EV loggers
must be placed face down in the interface. EVt loggers should be placed face up. For
N3000 Graphic Display Monitors, simply connect the comms lead to the connector on
the side of the instrument. The EV software will now interrogate the logger or monitor
automatically.
The EV software will display an information message as follows:
This is normal because the logger is not known to the software. Select OK to continue.
This message will be repeated whenever a new logger is introduced to the software.
This applies to new loggers not known to the software and to loggers known to the
system but with no active tasks.
Note the change in state of the Quick Program Icon and the Docked Icon. Both will now
be active.
If no further action is taken then the following information message will be displayed after
a 1 minute:*
*Note: This message will be displayed repeatedly if the logger is left on the interface.
In these circumstances the time shown will be updated.
To prevent the battery from being drained, click OK and remove the logger from the
interface. The Quick program and Dock Icons will return to their inactive states.
Note: Clicking OK and leaving the logger on the interface will resume battery
consumption.
For more information on this please refer to the user guide within the software
section 3.2 Software Setup Options.