Condux CableGlider LW Cable Puller - Manual (Page 12)

12
Operating Instructions
1. Select an adapter that corresponds to conduit size and fit it into the retaining fork.
2. Screw thumbscrew on retaining fork into adapter. (See Figures 5 & 6)
Figure 5 Figure 6
3. Position and adjust cable puller for desired application.
4. Thread pull line through adapter and across all of the sheaves.
WARNING: Inferior rope may break. Ensure the rope is rated for the load.
Failure to do so could result in serious personnel injury or death.
5. Manually tension the pull line and wrap it counter clockwise around the
capstan. Each wrap will yield approximately 20% more pulling power.
WARNING: The rope is under tension and could break. Stand at least 30° to
either side of the rope. Recoil force could cause serious personal injury or
death.
6. Re-adjust the puller if necessary to assure maximum stability against pulling torque.
4