Control Company 5200 WATERPROOF COUNTDOWN TIMER - Manual (Page 2)

REMOVABLE SUCTION CUP
To remove the suction cup located on the back of the
timer. Flip the timer over, so the back is facing up. Gently
pull the suction cup to the right, and the suction cup will
pop out.
To replace the suction cup. Place the ball of the suction
cup into the larger end of the mounting slot. Gently pull
the suction cup to the left, and the suction cup will pop in.
ALL OPERATIONAL DIFFICULTIES
If this timer does not function properly for any reason, re-
place the battery with a new high quality battery (see the
“Battery Replacement” section). Low battery power can
occasionally cause any number of “apparent” operational
difficulties. Replacing the battery with a new fresh battery
will solve most difficulties.
BATTERY REPLACEMENT
An incorrect display, no display or operational difficulties
indicate that the battery should be replaced. Using a
small screwdriver, unscrew the four screws located on
the back of the timer. Remove the battery cover. Remove
the exhausted battery and replace it with a new 1.5 volt
silver-oxide 357 size battery. Make certain the positive (+)
side is visible. Replace the battery cover. Screw the four
screws back into the unit. Do not over-tighten the screws
as this may cause damage to the battery cover.
WARRANTY, SERVICE, OR CALIBRATION
For warranty, service, or calibration contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281 482-1714 • Fax 281 482-9448
www.control3.com • [email protected]
Control Company is ISO 9001 Quality-Certified by DNV and
ISO 17025 accredited as a Calibration Laboratory by A2LA
Control Company Cat. No. 5200
Traceable ® is a registered trademarks of Control Company.
© 2013 Control Company. 92-5200-00 Rev. 0 073013
TRACEABLE
WATERPROOF
COUNTDOWN
TIMER
INSTRUCTIONS
®