Bosch Lavadora Next Premium - Manual (Page 33)

33
Fault Possible cause Action
Control lights do not light A fuse has blown. Replace the fuse of the individual circuit. g g
up.
Call Customer Service if this fault recurs.
Power failure. An interrupted program will be resumed when power
is restored. If the laundry is to be removed during a
power failure, call Customer Service
(refer to Page 35).
Appliance is in energyĆsaving mode.
This is not a fault.
Press the Select button; energyĆsaving mode is
terminated.
Program does not start.
Start/Pause indicator
light flashes.
Start/Pause button not pressed. Press the Start/Pause button.
Program does not start. Door not closed properly. Check whether laundry is trapped in door. g
"Check Door !" indicated
in the display field.
p p y
Close the door (a click should be heard).
Program continues.
"Press start" is indicated
in the display field.
End time selected but still not activated by pressing
the Start/Pause" button.
Press the Start/Pause button.
Program does not start.
"Real Time delay" is
indicated in the display
field.
End time selected and activated. None. Appliance starts automatically.
Clock cannot be set. Program has already started; when a program has
started, the clock cannot be set.
Wait until program ends.
"Set clock:" text remains
in the display field even
though the Menu button
has been pressed.
The setting has switched from hours to minutes; both
selection points have the same text.
None.
No time displayed. Time not set. Set time; see Page 27.
End time cannot be Time not set. Set time; see Page 27.
selected.
Program has already started; when a program has
started, the end time can no longer be selected.
Before starting the program, select and start the
desired end time; see Page 24.
Spin speed cannot be
selected.
Spinning is already in progress; during spin cycle the
speed cannot be changed.
Select speed before spinning.
Program selector is set to Drain; spin cycle is not
possible with this program.
If required, select another program.
Child lock cannot be
selected.
The program has already started. Child lock can be selected in pause mode.
Detergent residue in the Detergent was damp or lumpy. Clean and dry the detergent dispenser; see Page 30. g
detergent dispenser.
g p py
Use the cap of the detergent bottle to measure liquid
detergents.
Water does not enter the
machine or detergent is
Water tap not turned on. Turn on water tap.
Program continues. g
not washed away.
"Water tap closed?"
Supply hose kinked or pinched. Eliminate the cause.
"Water tap closed?"
indicated in the display
Strainers in supply hose clogged. Clean the water inlet strainers; see Page 30.
indicated in the display
field. Water pressure too low. Eliminate the cause.
Water cannot be seen in
drum.
This is not a fault.
The water level is below the visible part of the drum.