DATOptic Dual Internal FireWire Kit - Manual (Page 2)

Installing the DatOptic 1394 PCI host adapter
1) Turn off your computer, pull out the power cable and open up your computer.
2) Look for an available PCI slot and install the 1394 PCI host adapter into the
available slot.
3) Leave your computer open, plug in the power cable and turn on your
computer. Windows will boot up and detect the 1394 PCI FireWire adapter. If
you are using Windows98SE, you will need to download the Windows 98SE
FireWire patch. Windows ME/2000/XP may ask for your setup disk. After
Windows has detected the 1394 PCI FireWire adapter, power down your
computer and unplug the power cord. (Windows XP users must make sure
that your Windows XP version supports FireWire .)
Installing the DatOptic Dual FireWire Kit
1) Connect the DatOptic Dual FireWire Internal Kit into the first IDE device and
set the jumper to MASTER .
2) Connect the IDE cable into the second IDE device and set the jumper to
SLAVE .
3) Connect the 12 volt power cable that is connected into the Dual FireWire Kit
into the first IDE device.
4) Connect 2 spare 12 volt power cables from your power supply into the 12 volt
power connector on the first drive and another 12 volt power cable to your
second drive.
5) Connect the FireWire cable to any of the 2 ports from the DatOptic FireWire
Kit and the other end of the FireWire cable to your 1394 host adapter.
8) Plug in your computer power cable and power on your computer.
9) As soon as Windows has finished loading, go into your “Device Manager”,
double-click “DVD/CD-ROM drives” (if installing to CDROM/DVDROM), you
will see 2 additional lines. The first line will read “DatOptic FireWire Device” and
the second line will read “UNKNOWN VENDOR AND MODEL IEEE 1394 SBP2
DEVICE”.
If you are installing the Dual FireWire Kit onto 2 hard drives, you will see this
in your Device Manager under “Disk drives”.
10) Close up your computer case.