Despatch Protocol Manager with Protocol Plus - Manual (Page 17)

Protocol Manager Software E-100
13
Figure 12: Controller Setup Window
Name Field: Designate and type in the name of the oven or controller, up to 24
characters long, maximum.
Address Field: Type the address or move the slide bar of the Address field to
enter the address of the controller. (This field must correspond with the address
programmed into the controller on the Communication Page; see Manual E-98
for directions.) Values 1 through 247 are accepted.
Password Field: Type the password or move the slide bar of the Password
field to enter the password Level 2 of the controller. (This field must correspond
with the Level 2 password programmed into the controller on the Enable Page;
see Manual E-98 for directions.) Values from 1 to 999 are accepted. Default is 2.
Enable Communication Checkbox: Use the cursor to check this box to add it
to the list of controllers working under the software. If the status for the controller
shows DISABLED in the Status column of the Network tab of the Software
Setup window (see Figure 12), this box must be rechecked.
A controller can be disabled by leaving this box unchecked. Communication will
not be attempted with disabled controllers, which may be desirable if an oven is
shut off (not used) for a long period of time.
3. When the chosen parameters have been entered, press the Set button on
the popup. A question box will pop up (see Figure 13).