Det-Tronics SW9200x Slickwatch IR Oil Detection System - Manual (Page 16)

TROUBLESHOOTING
For assistance in rectifying set-up problems and simple
malfunctions, consult the Troubleshooting Table.
If malfunctions cannot be corrected by carefully follow-
ing the procedures described in this manual, contact the
factory for assistance. In many cases, sufficient informa-
tion to correct the malfunction can be provided over the
telephone. If it is necessary to contact the factory by
telephone, it is helpful to have the operation and mainte-
nance manual accessible and to obtain the following
readings for the service technician:
Instrument S/N_______________________________
Optionspurchased____________________________
RATIO _______________ VDC
DENOMINATOR _______________ VDC
NUMERATOR _______________ VDC
Oil Alarm Set Point ____________ VDC
Operating Height _____________ FT
General Description of Water Surface (Calm,
Turbulent, Oily, Flow Rate, etc.):
__________________________________________________
____________
Both field and factory service are available from Detector
Electronics. If it becomes necessary to return an instru-
ment to the factory, extreme care must be taken in pack-
ing the instrument for shipment. The monitor should be
enclosed in a plastic bag, surrounded with at least two
inches of foam or shipping pellets on all sides and
shipped in a heavy duty carton. Lack of sufficient cush-
ioning can cause extensive damage to internal compo-
nents. It is not usually necessary to return the transmitter
and, if carefully packed, just the receiver cover and
attached components can be shipped without the hous-
ing.
15 95-8409