Eberspacher EasyStart Timer Operating instructions - Manual (Page 10)

10 | VehiCLe heATeRs – TeChniCAL DOCuMenTATiOn
3 OpeRATiOn AnD seTTing/ADjusTMenT
hEatiNg immEdiatEly with lONgprEss
(withOut sEttiNgs)
press the LOngpRess button for longer than
2 seconds.
heater On.
30 min 21 °C
Display for air heaters in continuous heating mode
(factory setting).
21 °C
∞
plEasE NOtE!
After switching on, “On” is displayed for 2 sec and
then the remaining operating time or
for air
heaters.
set values are copied from the previous heating
mode.
if LOngpRess is pressed during heating mode the
display switches to the heATing submenu seT
TeMpeRATuRe seTpOinT – (only for air heater) and
seT OpeRATing TiMe.
During heating mode it is possible to switch to
another menu item. under the VenTiLATiOn menu
item, check the operating time and if necessary
adjust.
hEatiNg Off with lONgprEss
Display On, the heATing menu item is displayed.
press the
LOngpRess button for longer than
2 seconds.
heater OFF.
21 °C Off
After the heATing OFF the start display appears. if
the vehicle lighting is OFF the display lighting goes
out after 10 seconds.
17:30 21 °C
plEasE NOtE!
With heATing OFF with LOngpRess all active func-
tions are ended.
The following actions are possible during the
heATing OFF display:
use the
or button to select a menu item.
shORTpRess button, the start display appears,
if the shORTpRess button is pressed again,
Display OFF.
shORTpRess button, the heATing submenu is
displayed.