Eberspacher Calltronic 08 - Manual (Page 3)

3
Introduction
Dear Customer,
Thank you for purchasing the Calltronic
telephone remote control.
With this product you have a convenient
and innovative way of operating your
Eberspächer parking heater.
These operating instructions supple-
ment the explanations of your JE service
partner who installs the equipment and
summarise the functions of the Calltronic
once again.
Application
Your Eberspächer parking heater can be
remotely controlled by means of a phone
using DTMF data transmission. All mobile
and fixed line phones which enable multi-
frequency dialling tones to be sent are
suitable as controls.
When you call your Calltronic you are
guided through the menu and are enabled
to use the Eberspächer parking heater
located in your vehicle in an easy way.
Please note!
Before starting up the Calltronic, note •
and follow the general operating instruc-
tions of your Eberspächer parking
heater and note the location of your
vehicle.
In the case of water heaters it is neces-
•
sary to switch the vehicle's heating to
“Hot” before leaving the vehicle.
The vehicle blower must be set to level
1 if a 3 stage blower is used, to level 2 if
a 4 stage blower is used and to at least
1/3 of the blower output if a stepless
blower is used.
We recommend setting the heating
•
period to match the journey time to
avoid discharging of the vehicle's bat-
tery.
Example:
If the journey time is approximately 30
minutes (single trip) you should set the
heating period to 30 minutes.
The Calltronic is set to 30 min heating
•
period in the factory.
A once-off heating period of 10 – 120
•
minutes can be selected.