Eberspacher Calltronic 08 - Manual (Page 5)

5
Programming the Calltronic
Open the programming menu by entering 0 in the main menu
Programming menu Press the key sequence Note (see page 6)
Changing the password
1  new password
(2 digits)  #  repeat new
password  #
3
Heat
Changing the switched on
period
2  2 or 3 digits
(10 – 120 minutes)  #
3, 4
Ventilate
Changing the switched on
period
3  2 or 3 digits
(10 – 120 minutes)  #
3, 4
Programming the current time
4  2 digits ( Յ 23 hours) and
2 digits (
Յ 59 minutes)
3
Heating switching on time
5  2 digits ( Յ 23 hours) and
2 digits (
Յ 59 minutes)
3
Ventilation switching on time
6  2 digits ( Յ 23 hours) and
2 digits (
Յ 59 minutes)
3
Exit programming 0
Operating with pushbuttons
The scope of supply includes a pushbut-
ton. This must be installed and is used to
operate and display the current operating
status of your heater. When the button is pressed the last
control function is repeated. If the heater
is activated when the button is pressed
the current heating or ventilation cycle is
ended.
Heater operating status
LED in the pushbutton
continuously lit •
Æ Heating active
flashes slowly •
Æ Ventilation active
flashes quickly • Æ while the button is being pressed
Operation and Adjustment