Elkhart Brass SFL-GN-125 - Manual (Page 4)

B. The nozzle should be cleaned with a mild detergent
and nylon bristled brush. The nozzle should then be
inspected for damage (see Section III).
CAUTION: Petroleum based solvents are not recommended
for cleaning the nozzle. Using petroleum based solvents on
components such as the O-rings, gaskets, or the Hand Grip
may cause degradation resulting in premature failure.
C. The nozzle should then be attached to the stored
hose, with the Horshu-Handle placed in the “CLOSED”
position and the Nozzle Tip placed in the Wide Angle
Fog position.
D. Where practical, the nozzle should be stored with the
discharge down to prevent contaminants from collecting
in the nozzle.
III. Inspection of Nozzle
A. Nozzle Tip rotation: Rotate Nozzle Tip through all
positions several times. The Nozzle Tip should not bind
or stick. Return Nozzle Tip to the Wide Angle Fog
position.
B. Flush feature: Depress the pad on the Locking
Lever until the blade on the bottom of the Locking
Lever disengages from the notch in the Center Barrel
and rotate the Center Barrel counter clockwise as far
as possible. Release the Locking Lever and rotate the
Center Barrel back clockwise until the blade of the
Locking Lever snaps back down to engage the notch
in the Center Barrel. Repeat several times. The Center
Barrel should not bind or stick and the Locking Lever
4