Elkhart Brass Copperhead 8593-04 Monitor - Manual (Page 14)

14
 The monitor will oscillate between the limits until the oscillation button is pressed again. Pressing
the left or right button on one of the controllers will also stop the oscillation.
For safety reasons, once oscillation has stopped the oscillation limits need to be reprogrammed before
it can be re-engaged. The nozzle fog, stream, and discharge elevation functions can be operated
while the monitor is oscillating.
NOTE: It is recommended to set oscillation between the maximum left/right travel limits.
Manual Override
In the event of power failure to the monitor, the monitor may be actuated manually. To operate a
function manually, simply rotate the manual override handwheels.
NOTE: Using the manual override handwheels will alter the H2’s limit settings.
Important:
Using the horizontal override handwheel will move travel limits and stow
position from the original programmed positions. See Installation Step 4 to reset H2
travel limits and stow position.
Warning:
Do NOT use impact drivers to operate the manual override nuts. Serious
damage to motor gear heads will occur.
Storing the Monitor
Elkhart Brass recommends that a stow position be set and the stow routine be utilized to place the
monitor in its stowed position after each use.
These monitors have a user selectable stow position (see Programming Stow Position section for
instructions). After the water supply to the monitor has been turned off, simultaneously press the STOW
and FOG buttons on the primary panel mount RF transmitter (buttons must be held down for a
minimum of 3 seconds). The monitor will automatically rotate horizontally to the stow position
previously programmed, and either lower or raise the discharge (depending on the position of switch A
position 1 on the receiver board). The optional “stow indicator” will turn off after monitor reaches stow
position. The OEM primary transmitter will operate using the same inputs as listed for the primary
panel mount controller, provided the necessary switches are wired.
Any directional command (left, right, up, or down) will cancel the stow commence. To stow the
monitor, the stow command must be reactivated.
Warning:
Never activate the stow feature while water is flowing. Serious injury to
personnel and damage to apparatus could result.