Elkhart Brass Scorpion 8394-04 BRASS - Manual (Page 5)

7. STOW INDICATIOR SIGNALS (FOR ALL RELAY CONTROL BOXES):
a. STANDARD: The stow indication signal mode from the factory is for the stow
indicator signal, (stow light supplied by others), to come on solid once the
monitor has reached the stowed position.
b. NOTE - (See instructions for setting the OPTIONAL stowed indication signal
mode. In the optional mode the signal pulses, (The optional stow indicator would
flash) during the stow cycle and remain on solid once the monitor has reached the
stowed position. The stow signal voltage is 12VDC. Stow position setting and
signal mode may be used in any combination.
8. TO INITIATE THE STOW ROUTINE:
a. Make absolutely sure that NO water is flowing through the monitor. Push and
hold the button labeled “STOW” down for a minimum of 2 seconds and release to
activate the stow feature routine. (The 2 second delay is a safety feature to avoid
accidental activation of the stow routine) The stow feature can be activated with
the monitor in any position. (ATTENTION: IN CASE OF ACCIDENTAL
STOW ROUTINE ACTIVATION - OPERATION OF ANY MONITOR
CONTROL SWITCH OR BUTTON WILL ABORT THE STOW ROUTINE
!!!!!!)
Warning:
Never activate the “Stow” feature while water is flowing. Serious injury to personnel and/or
damage to property could result.
9. DESCRIPTION OF STOW ROUTINE:
a. The monitor discharge will move up or down to the set travel limit depending on
the P20 jumper position. (See step 1)
b. The monitor will move to the left, center, or right stow position depending on the
relay box part number.
c. For part numbers 81480001 & 81480101 the monitor will rotate to the left travel
limit and reverse direction rotating to the right travel limit and reverse direction
and rotate back to the left and center itself between the left and right travel limits
and stop.
d. For p/n 81480011 the monitor will rotate to the left travel limit and stop.
4