Quick attack pkg 1 install guide, Control components & accessories – Elkhart Brass Sidewinder Quick Attack Pkg 1 Install Guide User Manual

Page 2

Advertising
background image

Quick Attack Pkg 1 Install Guide:

Control Components & Accessories

2

4.

5.

6.

A. Follow mounting templates on page

30 of the instruction manual for hole

diameters and dimensions.

B. Drill holes for CAN network and

power cables for each components’

leads behind each component.

C. Mount components to panel using

10-24 x 1/2” screws. Use Loctite 242 or

equivalent.

D. Add a 1A (12VDC)* fuse between

red component lead and positive power

lead.

A. Connect entire CAN network together using 18-22 AWG. Ensure every component connected to the CAN network is connected in between 2 end components that

have CAN termination. Please refer to the BLUE, GREEN, and BLACK lines as the CAN wires below.

*.5A (24VDC)

- Joystick Controller

- OEM Interface Module

- Position Feedback Display

A. Install valve into plumbing. Torque

adapter bolts to spec using

Figure 1.

7/32” dia.

unless noted

CAN

Network

Wires

18g

98326010 Rev. A

NOTE: If you need to change

the orientation of the electric

actuator on top of the valve,

follow the instructions on

page 16 of the Unibody Valve

Manual (98311000). Manual

can be found at:

www.elkhartbrass.com/down

loads/manuals

Figure 1: Torque Specs

Valve

Torque

EB15

25-30 ft-lbs

EB20

25-30 ft-lbs

EB25

25-30 ft-lbs

EB30

38-40 ft-lbs

EB35

38-40 ft-lbs

EB40

60-70 ft-lbs

1

3

4

2

Tighten Adapter

Bolts using a

cross pattern

B. Add a 30A(12VDC)* fuse between

RED controller lead and positive power

lead. *15A(24VDC)

16g

oo

oo

o

o

o

o

o

o

o

oo

oo

ooooo

oo

o

o

o

o

o

o

o

oo

ooo

oooo

oo

o

o

o

o

o

o

o

oo

Advertising