Elkhart Brass Sidewinder Quick Attack Pkg 1 Install Guide - Manual (Page 3)

CALIBRATE HORIZONTAL ENTER SETUP MODE
EXIT SETUP MODE
SET MONITOR SPEED
SET KEEP-OUT ZONES
SET VER TRAVEL LIMIT SET HOR TRAVEL LIMIT
CALIBRATE VALVE
SET STOW POSITION
3 4 5
2 1
8
7 6
Quick Attack Pkg 1 Install Guide:
3
Setup Mode
Press and hold
<Aux> and
<Preset> until the
blue status LED
on monitor box
turns on.
NOTE: Changes
made will not
take effect until
after exiting
setup mode.
Press and hold
<Aux> and
<Preset> until the
blue status LED
on monitor box
turns off.
The following
steps are
optional (O).
Pressing the
<Osc> button will
cycle through the
monitor motor
speed options:
LEDs - Ver / Hor
0 - Fast / Fast
1 - Slow / Fast
2 - Fast / Slow
3 - Slow / Slow
Move monitor to
desired position,
then press <Fog>
and <Osc> at the
same time to
store a stow
position.
Stow position
must be within
allowed limits of
travel.
Move monitor to
a travel limit
position. Hold
<Stream>, and
move the joystick
forward to set the
lower limit, and
pull back to set
the upper limit.
MAX travel of
135° below the
pre-calibrated
“zero” position.
This step is
required (R).
Aim monitor at
center forward
“zero” position.
Hold <Preset>,
then move the
joystick to the
<Left> or <Right>
and hold until
status LED on
monitor blinks &
returns to solid.
NOTE: You will
also need to
calibrate the
valve before use.
While you are
NOT in setup
mode, press and
hold <Preset>
and <Close> for
approximately 5
seconds. The
valve will
a u t o m a t i c a l l y
start to calibrate
itself.
98326010 Rev. A
(R)
(O)
(O) Lower Left:
Move to top/right
corner of the
lower left zone,
hold <Preset>,
press <Close>,
and release both.
Lower Right:
Move to top/left
corner of the
lower right zone,
hold <Preset>,
press, <Open>,
and release both.
(O)
(O) Move monitor to
a travel limit
position. Hold
<Stream>, and
move the joystick
left to set the left
limit, and to the
right to set the
right limit.
MAX travel of
175° in either
direction from the
calibrated “zero”
position.
(O)
U
L
STATUS POWER
Preset
Preset
Stream
Preset
STATUS POWER
Lower Left Zone:
Top right corner
Lower Right Zone:
Top left corner
0°
Right Travel Limit Left Travel Limit
Lower Left
Zone
Lower Right
Zone
Close
Preset
Right
Left
Up
Down
R
L
Stream
Right
Left