Elkhart Brass Sidewinder Typical Pumper Truck Install Guide - Manual (Page 4)

Typical Pumper Truck Install Guide:
Button Press Logic
4
BUTT
ON LOGIC
PANEL
MOUNT
Button Press Logic: Panel Mount & Handheld Panel Mount Layout:
AUX
FOG
Straight Stream
OSC
Status LED
USB Port (Covered)
Power LED
To Stow
To Oscillate
Left, Right, Up, Down
Fog & Straight Stream
Valve Open & Close
Valve Auto Travel
To Change Valve Preset
Hold <Fog> and <Osc> until monitor begins to stow.
Press the <Osc> button at both extremities of the desired oscillation
pattern.
NOTE: You can manually control nozzle position while in a single
axis oscillation. Example: Up and Down will allow you to manually
control the vertical axis while in a horizontal oscillation. Any
direction in a two axis oscillation will stop the oscillation.
To auto travel OPEN, hold the <Open> button, then press <Close>, and
release both. The valve should fully open automatically. To CLOSE,
hold the <Close> button, then press <Open>, and release both.
Open or close the valve to the desired position. Press and hold the
<Preset> button until the preset light blinks (approx 10 seconds).
These function normally
These function normally
These function normally
Valve Preset
Opens or closes valve to a predetermined position
Horizontally Vertically Two Axis Oscillation
Open
Preset
Close
Valve Position LEDs
98326020 Rev. Rel
Monitor Directional
Control Buttons