Elkhart Brass SPIT-FIRE 08394059 Monitor - Manual (Page 7)

7
Monitor Cable Routing
1. Route cables as shown in Figure 2 below, so they will follow the vertical and horizontal movement
of the monitor. Make sure that the wire loops for horizontal and vertical movement is great
enough to eliminate any stretching of cables throughout the full movement of the monitor.
2. Wire tie cables together as shown in Figure 2 below. This will eliminate the cables from tangling.
3. Wire tie the nozzle cable to pressure gauge, allowing a long enough loop so vertical movement of
monitor will go to the full down position without stretching the cable.
Figure 2: Monitor Cable Routing