252-8 foam tube – Elkhart Brass ELKHART 253-9 Foam Tubes User Manual
Page 8
Advertising
- 4 -
3. 252-8 Foam Tube
To attach the foam tube to the nozzle first lift up on lever handle to open the jaw clamp
(see
), then carefully tilt the nozzle bumper into the half round portion of foam tube base
clearing the jaw clamp. Next*, press down firmly on the lever handle to fully clamp
nozzle into place (see
).
*Note: If the foam tube was manufactured before October 2008, make sure that the
cable screw and cam slot screw are positioned between the flats on foam tube,
Figure 5
Advertising
This manual is related to the following products: