BT verve 450 - Manual (Page 9)

Setting up for multiple packs
If you have purchased a BT Verve 450 multiple pack, you will
need to prepare any additional handsets and chargers for use.
For each additional handset and charger:
1. Insert the cable through the channel at the rear of the charger
and insert the plug into the power socket. Plug the other end
into the mains wall power socket and switch on.
2. The NiMH battery is already fitted in the handset. Remove the
battery compartment cover, by sliding it downward and lifting
off. Locate the battery lead and connector and plug it into the
socket inside the battery compartment (the red wire should be
on the left). Tuck the battery leads in the space above the
battery and slide the battery compartment cover back on.
Charge the battery for at least 20 hours.
9 Getting started
Using your BT Verve 450 on a
Broadband line?
If this product is to be used on a
broadband line then you must ensure
that it is connected via an ADSL
microfilter. Using this product on a
Broadband line without an ADSL
microfilter may cause problems with
this product and your Broadband
service.
Additional BT ADSL microfilters can be
purchased from www.shop.bt.com
If you experience any problems, please call the Helpline on 0800 218 2182* or email [email protected]