Elkhart Brass 2900E Series - Manual (Page 9)

8
6. Apply Loctite #242 to the four screws and reinstall them to secure the gear case to the
valve body. Torque the screws to 120-150 in-lbs.
7. Install the gear segment in the correct position as shown in Figure 1 above. Note that
rotating the worm slightly will ease gear segment installation.
8. Apply petroleum base grease to the thrust washer and install.
9. Reassemble the gear case cover on the gear case taking care not to damage the cover
O-ring.
10. Apply Loctite #242 to the four socket head cap screws and reinstall and tighten them
to secure the gear case cover.
Butterfly Valves;
1. Place the valve in the fully closed position. Note that the slot in the end of the actuator
shaft shows the position of the disc. When the slot is at a right angle to the waterway, the
valve is fully closed.
2. Remove the four socket head cap screws from the gear case cover, and then pull the
cover from the gear case. Rotating the cover slightly will ease removal.
3. Remove the thrust washer and gear segment from the gear case. Note that rotating the
worm slightly will ease gear segment removal.
4. Remove the four hex head bolts that secure the gear case assembly to the mounting
flange on the valve body.
5. Rotate the gear case assembly to the desired position while making sure the valve
remains closed.
6. Apply Loctite #242 to the four hex head bolts then reinstall and tighten them to secure
the gear case assembly to the mounting flange on the valve body.
.
7. Install the gear segment in the correct position as shown in Figure 2 above. Note that
rotating the worm slightly will ease gear segment installation.
8. Apply petroleum base grease to the thrust washer and install.
9. Reassemble the gear case cover on the gear case taking care not to damage the cover
O-ring.
10. Apply Loctite #242 to the four socket head cap screws and reinstall and tighten them
to secure the gear case cover.