Blaupunkt LAS VEGAS 7 645 650 310 - Manual (Page 34)

99
DANSK
ENGLISH
DEUTSCH
FRANÇAIS
IT
ALIANO
NEDERLANDS
SVENSKA
ESP
AÑOL
PORTUGUÊS
Setting the LPCM
This device can be used to output a
linear PCM signal (LPCM) with a sam-
pling rate of 48 K, 96 K or 192 K.
The LPCM setting is located under
“LPCM OUT” in the “SPDIF Setup”.
Dolby Digital Setup - Dynamic
Range Control
Dynamic Range Control means that
the difference between “loud” and “soft”
sounds is adjusted. The volume of soft
sounds is increased and that of loud
sounds is lowered. You can use the
DRC of the device to set the dynamics
of a Dolby programme in increments
from “OFF” to “Full”. Select the “FULL”
setting for full dynamic adjustment.
The setting of DRC is located under
“Dynamic” in the “Dolby Digital Setup”.
Setting the HDCD filter
If you play HDCD-DVDs or CDs (High
Definition Compatible Digital), you can
select a filter.
Select the desired filter under “HDCD”.
Video Setup - image settings
In the Video Setup, you can perform
different settings for an optimal image
playback on the connected display.
Adjusting picture sharpness
To adjust the picture sharpness, you
can select among the settings “High”,
“Medium” and “Low”.
The setting for picture sharpness is lo-
cated in “Quality” under “Sharpness”.
Brightness
You can adjust the brightness in incre-
ments from -20 to +20.
The setting for brightness is located in
“Quality” under “Brightness”.
Contrast
You can adjust the contrast in incre-
ments from -16 to +16.
The setting for contrast is located in
“Quality” under “Contrast”.
Gamma correction
You can adjust the gamma correction
for playback on TFT displays. You can
select among the settings “High”, “Me-
dium”, “Low”, and “None”.
The setting for gamma correction is
located in “Quality” under “Gamma”.
Colour
You can adjust the colour in increments
from -9 to +9.
The setting for colour is located in
“Quality” under “Hue”.
Colour saturation (for NTSC only)
You can adjust the colour saturation in
increments from -9 to +9.
The setting for colour saturation is lo-
cated in “Quality” under “Saturation”.
Luminance (for NTSC only)
You can select the settings “0T” and
“1T” for luminance.
The setting for luminance is located in
“Quality” under “Luma Delay”.
DVD OPERATION
02LasVegasDVD35_gb 08.07.2005, 14:16 Uhr 99