ElmoMC SimplIQ Analog Servo Amplifiers-Ocarina Installation - Manual (Page 6)

1.1 Warnings
To avoid electric arcing and hazards to personnel and electrical
contacts, never connect/disconnect the servo drive while the power
source is on.
Power cables can carry a high voltage, even when the motor is not in
motion. Disconnect the Ocarina and Castanet from all voltage sources
before they are opened for servicing.
The Ocarina and Castanet servo drives contains grounding conduits
for electric current protection. Any disruption to these conduits may
cause the instrument to become hot (live) and dangerous.
After shutting off the power and removing the power source from
your equipment, wait at least 1 minute before touching or
disconnecting parts of the equipment that are normally loaded with
electrical charges (such as capacitors or contacts). Measuring the
electrical contact points with a meter, before touching the equipment,
is recommended.
Cleaning after soldering
To avoid the damage of the product's acrylic coating the Flute must
not be cleaned after soldering by dissolving solvents and /or "water"
cleaning process. For more details:
www.elmomc.com/applications/article/Soldering-and-
Cleaning_Application-Note.pdf
1.2 Cautions
The Ocarina and Castanet servo drives contain hot surfaces and
electrically-charged components during operation.
The maximum DC power supply connected to the instrument must
comply with the parameters outlined in this guide.
When connecting the Ocarina and Castanet to an approved 12 ~ 95
VDC auxiliary power supply, connect it through a line that is
separated from hazardous live voltages using reinforced or double
insulation in accordance with approved safety standards.
Before switching on the Ocarina and Castanet, verify that all safety
precautions have been observed and that the installation procedures
in this manual have been followed.
Ocarina/Castanet Installation Guide Safety Information
MAN-OCSIG (Ver. 1.4)
1-2