ElmoMC SimplIQ Analog Servo Amplifiers-Ocarina Evaluation Board User Guide - Manual (Page 6)

1.1 Warnings
To avoid electric arcing and hazards to personnel and electrical contacts,
never connect/disconnect the servo drive while the power source is on.
Power cables can carry a high voltage, even when the motor is not in
motion. Disconnect the Ocarina Evaluation Board from all voltage sources
before it is opened for servicing.
The Ocarina Evaluation Board contains grounding conduits for electric
current protection. Any disruption to these conduits may cause the
instrument to become hot (live) and dangerous.
After shutting off the power and removing the power source from your
equipment, wait at least 1 minute before touching or disconnecting parts
of the equipment that are normally loaded with electrical charges (such as
capacitors or contacts). Measuring the electrical contact points with a
meter, before touching the equipment, is recommended.
1.2 Cautions
The Ocarina Evaluation Board contains hot surfaces and electrically-
charged components during operation.
The maximum DC power supply connected to the instrument must comply
with the parameters outlined in this guide. Furthermore, the power supply
must be isolated from hazardous live voltages using reinforced or double
insulation in accordance to approved safety standards.
When connecting the Ocarina Evaluation Board to an approved 12 ~ 95V
DC auxiliary power supply, connect it through a line that is isolated from
hazardous live voltages using reinforced or double insulation in
accordance with approved safety standards.
Before switching on the Ocarina Evaluation Board, verify that all safety
precautions have been observed and that the installation procedures in
this manual have been followed.
Ocarina Evaluation Board User Guide Safety Information
MAN-EVLBRD-OCA (Ver. 2.1)
1-2