Enerpac H700-Series - Manual

L2255 Rev. B 11/11
IMPORTANT RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage. If any shipping
damage is found, notify carrier at once. Shipping damage is NOT
covered by warranty. The carrier is responsible for all repair or
replacement cost resulting from damage in shipment.
DESCRIPTION
Enerpac supplies two different types of hydraulic hoses: thermoplastic
and heavy duty rubber. The thermoplastic hose has four layers, including
two high strength steel wire braids. The rubber hose is reinforced with
two layers of braided steel webbing.
WARNING
Do not use Enerpac hoses in systems exceeding 10,000 psi [700 bar].
Instruction Sheet
Hydraulic Hose / Fittings POWERFUL SOLUTIONS. GLOBAL FORCE.
Hose 700 Series Thermoplastic 900 Series Rubber
Design Factor
Expansion
4 to 1
Low
2 to 1
May expand under pressure
Flexibility
Less flexible Most flexible at low temperatures, but
tight bends can lead to damage
Tolerance to Fluids Inert to most fluids
Less tolerant to different types
of fluid
Tolerance to Heat Sensitive to heat More tolerant to heat
Durability of Outer
Covering
Abrasion-resistant Easily abused
Tolerance to High
Pressure Cycling
Very tolerant Less tolerant
HOSE COMPARISON
Index:
English:........................................................................... 1-4
Deutsch: ..........................................................................5-8
Français:........................................................................9-12
Español: ..................................................................... 13-16
Italiano:........................................................................17-20
Nederlands: .................................................................21-24
(1)