Brunton MapCreate 6 - Manual (Page 30)

J. After the MapCreate files have been installed on your computer, you are
prompted to install the MMC card reader drivers. Make sure the card reader is
not plugged in yet, then click O
K
to continue. (If you stop the program, you
can install the card reader later, but MapCreate will not run until the card
reader is installed. To install later refer to the instruction sheet that came with
the card reader.)
K. The setup program for the USB SD/MMC Reader loads.
L. When the setup program has loaded, a welcome screen is displayed. Click
the N
EXT
button when you're ready to begin the card reader installation.
24