ETC Eos Family v1.9.0 - Manual (Page 12)

E T C S u p p l e m e n t
Eos Family v1.9
Eos Family v1.9 Operations Manual Supplement Page 12 Electronic Theatre Controls, Inc.
• from a recorded macro instruction
• from the direct selects - {Snapshot 4}
Since snapshots can be recalled from any device (except RFRs) on the Ion network, snapshots
may be affected by the type of device they are recalled on. If the recalling device does not have the
same physical layout or has other limitations that differ from the recording device, Ion will map the
snapshot to the best of its ability.
Editing Snapshots
To edit or preview the contents of a snapshot, navigate to Browser>Record Target
Lists>Snapshots
You can use [Next] and [Last] to navigate the list or you may specify a snapshot in the command
line.
Once a snapshot is specified, the list displays five columns, one for each element. You may change
the enabled elements by pressing the CIA buttons or the softkeys found beneath the CIA. If an
element is added to the command line using the softkeys, it will be enabled when [Enter] is
pressed. All other elements will be disabled.
For Example:
• <Snapshots> [3] {Monitors} [Enter]
This command will enable the monitors for snapshot 3 and disable any other elements.
Deleting Snapshots
You may delete snapshots using the following syntax:
• [Delete] {Snapshots} [2] [Enter]
• [Delete] {Snapshot 5}
1-to-1 Submaster Mapping
The automatic 1-to-1 submaster mapping of Ion has been removed. A quick way to map the
submasters is still available.
In Blind, press [Sub] [1] [Thru] [Thru] [3][0][0] [Enter] which creates all 300 submasters. Now in
Live, press [Sub] [1] [Thru] [Enter], which selects all submasters created. Then you can hit the
load button for the first submaster and it will load all submasters sequentially.
You can also use the {Reset Subs 1 to 1} button in Browser>Clear.
Holding down the [Fader Control] button while a fader wing is attached will cause the last button
on the wing to toggle between Channel and Fader modes.