ETC Universal Fader Wing Setup Guide (Rev F) - Manual (Page 4)

E T C S e t u p G u i d e
Universal Fader Wing Setup Guide
Universal Fader Wing Setup Guide Page 4 of 6 Electronic Theatre Controls, Inc.
b: Remove and save the two screws securing the bumper to the side of the wing.
Step 2: Return the wing to its upright position.
Step 3: Remove the bumper(s) from the wing.
a:
Gently pull the bumper on the right side of the wing up until it is flush with the
facepanel. Gently push the bumper on the left side of the wing down until it
loosens from the facepanel.
b: Pull the bumper away from the facepanel until it is free from the wing.
Step 4: Repeat steps 2 and 3 for each side of each wing that needs to be exposed.
Step 5: Align the two wings. Lift the wing on the right and place it gently on the hooks provided
on the wing on the left. Check that the two wings are aligned properly front and back,
then press down gently on the wing on the right until it is fully seated. This should be
a smooth connection but may require a little force.
Step 6: Repeat above procedure to connect another wing to the right end of the pair, if
desired.
Step 7: Re-insert screws to secure wings together and secure the bumpers to the sides of the
wings.
1
1 2
3
bumpers on
either side
ETC Part number
HW117