ETC Universal Fader Wing Setup Guide (Rev F) - Manual (Page 6)

E T C S e t u p G u i d e
Universal Fader Wing Setup Guide
Universal Fader Wing Setup Guide Page 6 of 6 Electronic Theatre Controls, Inc.
Connect Universal Fader Wing(s) to Console with USB Cable
Step 1: With the console power off, attach the USB cable (provided) between the console and
one wing as shown above. If multiple wings are joined, only one power and one USB
connection may be used for all joined wings.
Step 2: Using the power supply adaptor kit, connect the fader wing to a power source.
Step 3: It is recommended that you run the power and USB cables through the strain relief
included on the back of the wings.
Step 4: Turn the console on.
C A U T I O N : Wings connected using a USB cable require an external power connection. An
external power supply was included with your Universal Fader Wing. This
connection remains active even after the console has been shut down. ETC
recommends unplugging the power connection after shutting down the console.
connect to USB
on the console
connect PS372
12VDC power supply
cable
(included)
connect
USB cable
(included)