Shaping the beam, Pattern projection, Drop-in iris slot – ETC Source Four jr and jr Zoom CE User Manual User Manual
Page 9
7
English
beam focus knobs to set the beam’s spread and to focus the edge of the beam. The Zoom lens
provide a range from 25° to 50°.
Step 1:
Loosen the beam focus knob(s) on the underside of the barrel as shown in
Figure 6
.
Step 2:
Slide the lens(es) forward or backward to achieve the desired beam edge.
Step 3:
Once the luminaire is focused, tighten the beam focus knob(s).
Shaping the beam
The beam can be shaped using the shutters (see
Figure 8
), a pattern or an optional drop-in iris.
Pattern Projection
The pattern holder slot is on the top side of the barrel and in front of the shutters. It accommodates
an M-size pattern holder (see
Figure 7
). The pattern holder handle can be bent away from the
shutter handle to keep it from interfering with the action of the shutter handle.
Use an optional donut in the accessory holder to enhance pattern projection. Donut diameter range
should be 6.35 cm to 6.98 cm (2.5” to 2.75”).
Drop-In Iris Slot
The drop-in iris slot is located on the top of the barrel and in front of the pattern holder slot. It
accommodates either a drop-in iris or a motorized pattern device. When the slot is not in use, a
small sheet metal cover secured with two Phillips screws prevents light leakage (see
Figure 8
).
Step 1:
Use a Phillips screwdriver to loosen the screws on the drop-in iris slot cover. Do not
remove screws.
Step 2:
Slide the cover completely forward to expose the slot.
Step 3:
Insert the iris with the flat side toward the shutters and make sure the iris handle extends
from the slot.
Figure 7
M-Size Pattern holder
Drop-in iris slot
Iris
Figure 8
Pattern holder slot
Shutters