Iii. attaching the wheels – Burley BEE User Manual
Page 4
4
Burley Bee Owner’s Instruction and Safety Manual
III. Attaching the Wheels
First, verify that the tires are infl ated to 30-35 P.S.I. Next, tip the trailer frame on its
back end. If you are work ing on a rough or dirty sur face, lay down a cloth or other
protective barrier to avoid damage to your trailer. With the quick-release lever in the
"OPEN" position, insert the wheel axle assembly com plete ly into the hollow trailer
axle, making sure that the hor i zon tal shaft goes all the way into the axle.
NOTE: The spoked wheels in stall with the inset side of the hub
facing outward.
Once the wheels are fully seated in the hollow axle, the quick-release lever should
be positioned so that it is aimed to the rear of the trailer in the “CLOSED” position
(the lever is marked for OPEN or CLOSED positions). The wheel quick-release/axle
assembly comes preadjusted from Burley.
Make sure wheels are held securely, with wheel shaft fully
inserted into the hollow axle. You should not be able to rock
or shift wheels. Improperly installed wheels can fall off, caus-
ing an accident or serious injury.
With wheels mounted, both refl ectors must face outward.
Check to see that both refl ectors have been installed cor-
rectly. Incorrectly installed refl ectors can reduce visibility at
night and cause an accident or serious injury.
Quick-release lever
in unlocked “OPEN”
position
Quick-release lever
in locked “CLOSED”
position