Flex TPO Clear Cut-Edge Sealant - Manual (Page 2)

___________________________________________________________________________________________________
Flex Membrane International Corp. 2670 Leiscz’s Bridge Road, Suite 400, Leesport, PA 19533
Tel: (610) 916-9500 Fax: (610) 916-9501 www.FlexRoofingSystems.com
Page 2
CAUTIONS AND WARNINGS
1. Review the applicable Material Safety Data Sheet for complete safety information.
2. Flex TPO Clear Cut-Edge Sealant has a tendency to settle. SHAKE WELL PRIOR TO EACH
USE.
3. Flex TPO Clear Cut-Edge Sealant is FLAMMABLE -- It contains solvents that are dangerous fire
and explosion hazards when exposed to heat, flame or sparks. Do not smoke while applying. Do not
use in a confined or unventilated area. Vapors are heavier than air and may travel along the ground
to a distant ignition source and flashback.
4. Avoid breathing vapors. Keep container closed when not in use. Use with adequate ventilation. If
inhaled, remove to fresh air. If not breathing, perform artificial respiration. If breathing is difficult,
give oxygen. Call a physician immediately.
5. If swallowed, DO NOT INDUCE VOMITING. Call a physician immediately.
6. Avoid contact with eyes. Safety glasses or goggles are recommended. If splashed in eyes,
immediately flush eyes with plenty of water for at least 15 minutes. Contact a physician
immediately.
7. Avoid contact with skin. Wash thoroughly after handling. In case of contact with skin, thoroughly
wash affected area with soap and water.
8. Job site storage temperatures in excess of 90ºF (32°C) may affect product shelf life. Should the Flex
TPO Clear Cut-Edge Sealant be stored at temperatures below 60ºF (15°C), restore to room
temperature prior to use.
9. KEEP OUT OF THE REACH OF CHILDREN.
*Physical properties. Typical properties and characteristics are based on samples tested and are not
guaranteed for all samples of this product. This data and information is intended as a guide and does not
reflect the specification range for any particular property of this product.
** REVIEW CURRENT FLEX SPECIFICATIONS AND DETAILS FOR SPECIFIC APPLICATION
REQUIREMENTS.