Black & Decker CTO6301 - Manual (Page 4)

BAKE FUNCTION
Selecting Cooking Temperature and Time
CAUTION: Unit gets hot. NEVER touch outer surfaces, including the glass door. Always
use oven mitt or pot holder.
Note: You have five seconds for selecting the temperature and time. If you exceed this
time, the display will change back to the default (000) temperature and time; simply
repeat steps 1-5 to begin again.
1. Press BAKE button. The unit beeps, On indicator light blinks
and 350°F (180 °C) default temperature flashes on the digital
display (E).
2. To change the temperature, immediately press ( ▲) or (▼) button
until you reach desired temperature (F).
Note: Cooking temperature can be adjusted from 200˚F to 450˚F
(93 ˚C - 232 ˚C).
• Tap button and release to change in increments of 5 degrees.
• Press and hold button to change rapidly in increments
of 25 degrees.
3. To set the cooking time, press the TIME button. If you just plugged
in the unit, the default cooking time of :30 (30 minutes) flashes on
the display (G); otherwise it will display the last selected time.
6 5
How to Use
This product is for household use only.
GETTING STARTED
• Remove packing materials and any stickers. Peel off clear protective film from control
panel.
• Wash all parts as instructed in Care and Cleaning.
• Select a location for the unit. Leave some space between the back of the unit and
your wall to allow heat to flow without damaging cabinet and walls.
• Insert crumb tray underneath the bottom heating elements.
• Untie the cord and unwind it.
• Plug unit into electrical outlet. 0 00 shows on the digital
display (C).
Important: During the first few minutes of use, you may
notice smoke and a slight odor. This is normal and is not a
cause for concern.
HELPFUL INFORMATION ABOUT YOUR OVEN
• You can change the temperature from ˚F to ˚C by pressing the
▲ and ▼ buttons
simultaneously.
• For your convenience, the unit always remembers the last selected setting unless
unplugged. You can change this setting before the oven begins preheating or once it
has reached the preset temperature and time.
• You cannot change the temperature or time during the preheat cycle. Once the set
temperature is reached, you can then change the temperature or time at any time.
• If using convection bake, remember to lower the suggested temperature of a recipe or
package by 25˚F.
• Unit gets hot. NEVER touch outer surfaces, including the glass door. Always use
oven mitt or pot holder.
SLIDE RACK POSITIONS
There are four positions for the slide rack (D). It can be inserted in either the upper or
lower slot. It can also be inverted for two additional positions.
C
E
F
Position 1
Use upper slots along
oven walls. Insert rack
using a rack-up position. Position 2
Use lower slots along
oven walls. Insert rack
using a rack-up position.
Position 3
Use upper slots along
oven walls. Insert rack
using a rack-down
position.
Position 4
Use lower slots along
oven walls. Insert rack
using a rack-down
position.
D G
CTO6301Pub10000003004R1 8/25/06 7:00 AM Page 6