INCRA Miter Slider - Manual (Page 6)

INCRA MITER SLIDER OWNER’S MANUAL & JIG PLANS
Manufactured by: Taylor Design Group, Inc. P.O. BOX. 810262 Dallas, TX 75381 W W W . I N C R A . C O M
Page 6
build-it system jig plans
B
ased on a simple shooter board styled squaring jig, this wonderful implementation of the Built-It System components offers much
more than just 90 degree cutoff control. The T-Track Plus and user-made stop positioner provide repeatable crosscut length control.
The rear mounted T-Track Regular combined with a pair of Build-It Brackets along with the twin T-Slot Panel Connectors allow for unlimited
adjustment of the fence angle. And the locking drop panel safely catches any off cuts from your workpiece.
Begin by adding a Miter Slider to a small Build-It Panel. Place in your table saw’s miter slot and adjust for a good fit, then add a T-Slot
Panel Connector to each edge. Increase the platform width away from the blade by adding another Build-It Panel. Add a large Build-It
Panel to the opposite edge. Trim to the blade and then use the remaining piece of the large panel along with another Miter Slider to
make the drop panel as described in
Steps 3 through 7 shown on the reverse
side of your Build-It Panel’s wrapper.
Make the 24” fence and stop as shown
in Fig. 3 and Detail 3A using 24” T-Track
Regular and T-Track Plus components,
then attach to the T-Slot Panel Connectors
using a pair of Built-It Brackets. Lock the
drop panel adjacent to the saw blade to
catch the off cuts, adjust the fence angle
to suit
your
project
and cut
away.
Adjustable Angle Crosscut
w/Drop Panel
Fig.1 Fig.2
Fig.3
Detail 3A
Build-It Platform Components Required:
• 1 Large Build-It Panel • 2 Small Build-It Panels
• 2 Miter Sliders • 2 T-Slot Panel Connectors • 24” T-Track Regular • 24” T-Track Plus
• Build-It Knobs • Build-It Brackets • Build-It Clamp
Just add:
5 /1
6”
d
ia
ho
le
s
2 1 / 16 ”
Large Build-It Panel
trimmed to Blade
(For more info on trimming this panel to your
blade for zero clearance see steps 3 through 7
on the reverse side of your Build-It
Panel’s wrapper.)
24” T-Track Regular
3 / 4 ”
2”
1 1 / 8 ”
3 1 / 2 ”
2 3 / 16 ”
3 / 4 ”
1 3 / 4 ”
1 1 / 4 ”
5 / 8 ”
3 / 4 ” wide
x 1 / 2 ” deep
groove for
T-Track
3 / 4 ”
24” T-Track Plus
Plan # 001