Bissell QuickSteamer 1950 series - Manual (Page 10)

10
When you’re done
Turn Power Switch to OFF ( ) position.
Unplug Power Cord from outlet.
Remove and empty Dirty Water Tank.
a. Press detent Pedal and tip Handle back, laying it
gently on floor.
b. Release Dirty Water Tank latches [1 each side] by
pulling up from bottom of latch and then out.
c. Carefully lift Dirty Water Tank from Lower Body.
d. Carry Dirty Water Tank to a toilet or sink. To empty,
pour out contents using opening at back of Tank.
e. Fill Dirty Water Tank with clean water through the
Vent Cover and rinse thoroughly. Discard water.
Replace Dirty Water Tank on Lower Body and secure with
latches. Replace Clean Water Tank.
Wrap Power Cord around Quick Release Cord Wrap on
side of QUICKSTEAMER.
Wipe all surfaces with a soft cloth. Store cleaner upright
in a protected, dry area.
NOTE: You may have cleaning solution remaining
in the Clean Water Tank. You may store your
QuickSteamer this way for the next cleaning
task, but never keep soiled solution in the Dirty
Water Tank.
CAUTION:
Do not store unit where
freezing may occur. Dam-
age to internal
components may result.
a.
b.
c.
d.
Vent
Cover
e.
Reduced spray or no spray.
Possible Causes Remedies
Clean Water Tank empty Refill Tank with water and formula
Spray Bar clogged Clean Spray Bar
Deep Cleaner not picking up cleaning solution.
Possible Causes Remedies
Dirty Water Tank not aligned/secured Check Tank for proper alignment and secur
with side latches
Dirty Water Tank is full Empty Tank
Trouble Shooting
Routine Maintenance