Bissell QuickSteamer 1950 series - Manual (Page 7)

7
Turn Power Switch [located on the back of the Lower
Body] to ( ) ON.
With foot, press the Detent Lever on right side of Lower Body.
Depress Spray Trigger to spray cleaning solution.
Do not overwet.
Repeat motion over same area without depressing Trigger.
Repeat Steps 3 and 4 until no more dirt can be removed.
Continue to clean entire carpet, working in 3’ x 4’ sections.
Empty the Dirty Water Tank when dirty water reaches the
full line, or when the Clean Water Tank is empty. See
page 10 for instructions.
If Floor Nozzle stops spraying, turn Power Switch to OFF
( ) and check water and cleaning solution levels. Refill
if needed.
*Bare Floor Cleaning is only available on select QuickSteamer
models without the DirtLifter
® PowerBrush. If your QuickSteamer
did not come so equipped, you may order one through BISSELL
Customer Service at 1-800-263-2535. You can also visit the
BISSELL Web Site: www.bissell.com.
NOTE: Your QuickSteamer is not recommended for cleaning wood floors.
• Use only BISSELL ® Floor Cleansing Formula ™ on no-wax floors.
Never use BISSELL carpet cleaning formulas on bare floors.
• Sweep or vacuum before starting.
• Remove old wax before cleaning.
• Leave an exit path for yourself.
• Allow at least 1/2 hour drying time.
Remove Dirty Water Tank.
Remove Brush by depressing tabs on the Cross Action
Brush
™ outward with thumbs until the Brush loosens.
Add Bare Floor Tool underneath the Floor Nozzle by sliding
notches and tabs into the opening until it is secure. Make
sure tabs on the Bare Floor Tool snap over front lip of
Floor Nozzle.
Replace empty Dirty Water Tank.
Attaching the Bare Floor Tool - 1950 Series only
Deep Cleaning
1.
2.
8.
3.
4.
5.
6.
7.
Tip:
It is recommended that
every time your Clean
Water Tank is emptied
of solution that you
empty the contents of
the Dirty Water Tank. If
the Dirty Water Tank
gets too full, you may
begin to see foam
spitting out of the vent
cover. When this
happens you will know
it is time to empty the
Dirty Water Tank.
Bare Floor Tool
(select models only)
Dirty Water Tank
7.
1.
2.
3.
4.
CAUTION:
The Dirty Water Tank
holds approximately 1/2
gallon of soiled liquid.
Filling past the fill line
can damage unit.
Tabs
Floor
nozzle
front lip
Vent
Cover