I.R.I.S. 316 User Manual
Page 8
Hardware Installation
Fix camera to mounting plate, routing umbilical cable through cable entry hole, then fix mounting plate to surface. Camera can be
installed either in the hanging orientation as shown below, or in the ʻdesktopʼ orientation as shown in the inset.
M5 x 10mm Countersunk Screws
(Supplied) in 3 positions.
Fix Mounting Plate to base of camera
M5 x 10mm Countersunk Screws
(Supplied) in 3 positions.
Fix Mounting Plate to base of camera
Cable Entry
Route umbilical cable through here.
Standard (or ʻDesktopʼ) Orientation
The camera is factory set for installation in the ʻStandardʼ orientation as shown here.
To install in the hanging orientation as shown in the main image above, ensure the
cameras video output has been set to vertical flip. This can either be done via your
controller or via the DIP switches. Details are provide later in this document.