I.R.I.S. 295 - Manual (Page 10)

6.01 Hardware Installation
Get to know your NightRunner!
The different parts of your camera are labelled here:
Once youʼve established a suitable fixing position, offer the
camera into place to mark off the six Surface Fixing Positions
and the cable clearance position.
The camera is supplied with 6 x Stainless Steel, 1/4”x3/4” self
tapping screws. Drill pilot holes accordingly and use a 30mm
hole saw to create the cable entry hole.
When the CAT5 cable is correctly terminated (see next section),
offer the camera up into the fixing position and firmly screw into
place.
Observe extreme caution when siting the camera. Ensure the
act of drilling the pilot holes and cable entry hole does not
infringe any cables, equipment or fixtures behind the panel onto
which the camera is to be installed.
To avoid moisture ingress between the bottom of the camera
and the surface onto which the camera is to be attached, apply
a bead of suitable silicone sealant around the edge of the plate
to create a seal.
V2.05 Iss 17-07-14: 10
Daylight Camera Lens Window
Protective lens window for daylight camera.
Germanium Lens Window
Protective lens window through
which heat is conducted. This is
manufactured through a material
called Germanium - not glass.
Thermal Imaging cameras cannot
ʻseeʼ through glass.
Inner Dome
Contains the thermal camera
module and tilt motor
Protective Cowling
Shields the Inner Dome and Tilt
Pivot points
Base Section
Contains the telemetry
data circuitry and Pan
motor
DIP Switch Window
Protects switches for Camera
Address and other features.
Camera Connector
Waterproof RJ45 Connector for camera
Power, Video & Data.
Base Plate
Do not remove. Protects pan motor and
telemetry data circuitry.
Fixing Points
1/4” Clearance holes in six positions for
fixing camera in place.
IRIS295 Thermal Imaging / Daylight Dual Payload PTZ Camera in Standard (Desktop) Orientation.
This style of housing is known as the NightRunner Series Housing.