I.R.I.S. 075 User Manual
Page 5
fixtures in it's intended position (such as doors or walkways for
example). If possible, power the item up and offer the camera up in the
vicinity of the desired installation position to double check suitability.
Cabling:
The camera has a 45cm cable tail which has a 2.5mm DC Barrel Jack (female)
to connect power and a 75Ω BNC (female) connector for the video signal,
therefore it will be almost inevitable that the power, data and video cables will
need to be extended. In a typical installation, the video cable will need to be
routed back to the monitor (or chart plotter), the data pair will need to be
routed back to the controller or RS485 Data Distributor in larger installations
and the power pair will need to be routed back to the boats distribution panel.
See the illustration below:
Fig:1.0. Very Basic Installation. Single camera with video output into MFD.
Iris Innovations: IRIS106 User Guide. v1.00 072013
Power
Distribution Panel
12VDC
Composite Video 75Ω 1V P~P
12VDC Power