Bel Canto Design SET 40 - Manual (Page 7)

SET 40 Owner's Manual Page 7
Connecting and Use
Connecting the SET40 into
Your System
Input Connections
There is one pair of RCA input jacks for the
analog inputs. The right channel is marked with
a Red band and the left with a Black band.
Loudspeaker Connection
The loudspeaker connections use one of the
two pairs of output jacks behind the output
transformer on the top plate of the chassis. The
output jacks accept many types of wire
termination, although we recommend either a
high quality spade lug or the use of simple tinned
wire terminations for this hookup.
Determine the nominal impedance of your
loudspeaker. The 8 ohm switch position should
be used with loudspeakers which have greater
than 6 ohm minimum impedance. The 4 ohm
position should be used with loudspeakers with
3 to 6 ohm minimum impedance. The impedance
selector is between the loudspeaker outputs.
Power Switch
The rear panel power switch marked 0 1 will
take the amp out of standby when switched to
the 1 position. The input tube filaments are
always powered to insure a gentle turn on and
instant sound output.
Tube Life and Replacement
The 845 output tubes are designed for
commercial use in and will provide at least 8000
hours of life as used in the SET circuit. This
translates to over 5 years of typical use. The
input tubes generally have 2000 hour life and
will need replacement every 1 1/2 to 2 years.
These tubes are available off the shelf from
current production at reasonable prices. Contact
your dealer or Bel Canto Design for
replacement.