Using mmc, Operating mmc-compatible devices with the br-900cd, 160 synchronizing with midi devices – Boss Audio Systems BR-900CD User Manual
Page 160
160
Synchronizing with MIDI Devices
Using MMC
MMC stands for “MIDI Machine Control.” This is a protocol
that uses MIDI System Exclusive messages to remotely
control multiple recording devices from one device. Your BR-
900CD supports the MMC protocol.
By using MMC, your BR-900CD can send commands such as
PLAY, STOP, and FF to connected MIDI devices to operate
them.
Some MIDI devices do not support the BR-900CD’s MMC
functionality. If so, it will not be possible to operate them
from the BR-900CD using the procedures described here. For
details on the MMC functionality supported by the BR-
900CD, read “MIDI Implementation” (p. 216).
Operating MMC-compatible
devices with the BR-900CD
This section explains how to make settings for synchronizing
the playback with a computer-based sequencer program that
supports MMC and MTC. Make connections as shown in the
diagram below.
fig.05-409
The BR-900CD will be the master for MMC and MTC.
Follow the procedure given below to operate the play, stop,
fast-forward and other functions of a sequencer program
with the BR-900CD.
1. Press [UTILITY].
2. Press CURSOR [
] [
] to move the cursor to
“SYNC,” and press [ENTER].
fig.05-410d
3. Press CURSOR [
] [
] to select “MMC Master,” and
turn the TIME/VALUE dial to set the MMC mode.
fig.05-411d
OFF:
MMC will not be transmitted.
ON:
MMC information is sent. The BR-900CD
becomes the master of the external MIDI
instrument.
* For details on the MMC functionality supported by the BR-
900CD, read “MIDI Implementation” (p. 216).
4. Press CURSOR [
] [
] to select “Sync Gen,” and
turn the TIME/VALUE dial to set “MTC.”
5. Make settings on your sequencer software.
Make the following settings on your sequencer software.
For details on making these settings, refer to the manual
for your sequencer software.
MTC:
receive
MTC type:
same setting as the MTC Type selected on the
BR-900CD
MMC:
receive
6. Press [UTILITY] (or press [EXIT] repeatedly) to return
to the Play screen.
* During updating, “Keep power on!” appears in the upper line
of the display, while the lower line shows what is being
processed.
MIDI IN
MIDI OUT