Boss Audio Systems BR-900CD - Manual (Page 167)

167
With Windows
Section 7
Loading WAV/AIFF Files in BR-
900CD Tracks (WAV/AIFF Import)
You can take WAV or AIFF files on your computer, such as
files created with audio software applications, and load them
to the BR-900CD’s tracks.
● Wave data in the following formats can be imported.
You cannot import wave data in other formats.
• WAV or AIFF format
• Mono or Stereo
• 8-bit or 16-bit
• Sampling Rate: 44.1 kHz
● Add the extension “WAV” to imported WAV files and
the extension “AIF” to imported AIFF files.
● Compressed WAV files or AIFF files cannot be loaded.
● Extremely short waveform data (less than
approximately 1 sec) cannot be loaded.
● The loop point settings within an AIFF file will be
ignored.
● If the unit is in the Arrange mode at the time of the
import, it takes place in accord with the timing of the
Arrange mode. On the other hand, if the unit is in the
Pattern mode at the time of the import, it takes place in
accord with the timing of the Pattern mode.
1. Connect your computer and the BR-900CD with a USB
cable.
2. Confirm that the recorder is stopped, then press
[UTILITY].
3. Press CURSOR [ ] [ ] to move the cursor to “USB,”
and press [ENTER].
The USB screen appears.
4. Select “IMPORT” with the TIME/VALUE dial, then
press [ENTER].
fig.06-120d
5. Use CURSOR [ ] [ ] and the TIME/VALUE dial to
select the track and V-track to be loaded, then press
[ENTER].
When loading to the tracks in mono
fig.06-122d
When loading to the tracks in stereo
* Select the track combination 1/2, 3/4, 5/6, or 7/8.
fig.06-121d
6. Use [CURSOR] and the TIME/VALUE dial to specify
the measure or position in the track from which
loading is to start, then press [ENTER].
fig.06-123d
The “BOSS_BR-900” (or “Removable disk (*:)”) icon is
added to the computer.
fig.06-104
BOSS_BR-900 Removable Disk (*:)
(Ex.)