JUMO 709061 TYA 201 - Single-Phase Power Controller Operating Manual User Manual
Jumo tya 201 single-phase scr power controller
Advertising
Table of contents
Document Outline
- 1 Introduction
- 2 Installation
- 2.1 Important installation notes
- 2.2 Dimensions
- 2.2.1 Type 709061/X-0X-020-XXX-XXX-XX-25X
- 2.2.2 Type 709061/X-0X-032-XXX-XXX-XX-25X
- 2.2.3 Type 709061/X-0X-050-XXX-XXX-XX-25X
- 2.2.4 Type 709061/X-0X-100-XXX-XXX-XX-25X
- 2.2.5 Type 709061/X-0X-150-XXX-XXX-XX-25X Type 709061/X-0X-200-XXX-XXX-XX-25X
- 2.2.6 Type 709061/X-0X-250-XXX-XXX-XX-25X
- 2.2.7 Clearances (all types)
- 3 Electrical connection
- 3.1 Plug-in screw terminals
- 3.2 Cable lugs and plug-in screw terminals
- 3.3 Connection diagram
- 3.3.1 Single-phase operation: phase / N
- 3.3.2 Single-phase operation: phase / phase
- 3.3.3 Star connection with accessible star point (N)
- 3.3.4 Open delta connection (six wire connection)
- 3.3.5 Free-running economy circuit with purely resistive loads
- 3.3.6 Master-slave three-phase current economy circuit for resistive loads in star, delta connection, or transformer loads (resistive-inductive)
- 4 Operation
- 5 Configuration
- 6 Special device functions
- 6.1 Detection of load faults
- 6.2 Manual mode
- 6.3 Default setpoint value via potentiometer
- 6.4 Dual energy management
- 6.5 Subordinate control
- 6.6 Resistance limitation (R control)
- 6.7 Current limiting
- 6.8 a start
- 6.9 Monitoring of the supply voltage drop
- 6.10 Firing-pulse inhibit
- 6.11 SCR control logic (switch)
- 7 Setup program
- 8 Fault messages and alarms
- 9 What to do, if ...
- 10 Technical data